08-30-2007 10:01 AM - edited 03-03-2019 06:32 PM
Does anyone have a template config to share? This is my first time setting DSL and it does not want to work. Carrier is AT&T/SBC in Reno Nevada. My ATM0/0/0 is up/up but I am not receividng packets
08-31-2007 05:11 AM
This worked for me: (verizon was the carrier)
hostname ADSL
!
vpdn enable
no vpdn logging
!
vpdn-group pppoe
request-dialin
!
protocol pppoe
!
interface FastEthernet0
ip address 10.92.1.182 255.255.255.0
ip nat inside
!
interface ATM0
no ip address
no atm ilmi-keepalive
bundle-enable
dsl operating-mode auto
hold-queue 224 in
!
interface ATM0.1 point-to-point
pvc 0/35
pppoe-client dial-pool-number 1
!
interface Dialer1
ip address negotiated
ip mtu 1492
ip nat outside
encapsulation ppp
dialer pool 1
ppp authentication pap chap callin
ppp chap hostname (scrubbed)
ppp chap password (scrubbed)
!
ip nat inside source list 1 interface Dialer1 overload
ip classless
ip route 0.0.0.0 0.0.0.0 dialer1
ip http server
ip pim bidir-enable
!
access-list 1 permit 10.92.1.0 0.0.0.255
!
end
08-31-2007 07:17 AM
Thanks! That did the trick for me. I was using the VCI/VPI pair they gave me on their Speedstream modem which would function there.
When I changed to 0/35 it worked.
08-31-2007 05:28 AM
check your NAT...commands are on place??
ip nat inside source list 1 interface Dialer1 overload
ip route 0.0.0.0 0.0.0.0 dialer1
access-list 1 permit 10.92.1.0 0.0.0.255
Regards,
Dharmesh Purohit
08-31-2007 07:20 AM
Thanks for the suggestion, it was my VCI/VPI setup. I had been using the pair issued by AT&T. When I changed to 0/35 it deciced to work. Go figure.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide