ARP Information on Viptela vEdge Devices via SNMP

[carstenInfraray]

Hello everyone,

I've been attempting to retrieve ARP information from a Viptela vEdge device using SNMP, but haven't been successful. Specifically, I tried the following OIDs but did not receive any information:

• ipNetToMediaIfIndex: 1.3.6.1.2.1.4.22.1.1
• ipNetToMediaPhysAddress: 1.3.6.1.2.1.4.22.1.2
• ipNetToMediaNetAddress: 1.3.6.1.2.1.4.22.1.3
• ipNetToMediaType: 1.3.6.1.2.1.4.22.1.4

Can anyone confirm if these devices maintain ARP tables? If so, what is the specific OID or MIB to access this information? Or is it possible to get those details via CLI?

Thank you in advance for your insights!

[Kanan Huseynli]

Hi,

"show arp" is the vEdge command which shows ARP entries.

Regarding, SNMP I don't sure is there any MIB that shows it

[carstenInfraray]

Hey, thanks for your reply.
So far I have found no private MIB which contains the ARP information.

Via CLI it is clear how to get those, but not via SNMP.

[guruvignesh · Accepted solution]

Hello carsteninfraray,

SNMP OIDs mentioned may not provide ARP info for Viptela vEdge. Use CLI show arp. Look for vendor/device-specific MIBs. Perform an OID walk to explore available OIDs for ARP.