Deploying configuration using Configuration Groups Optional ?

[Stevo8300]

When deploying SD-WAN configuration using new Configuration Group method. How do you make certain parts optional when deploying configuration.  For example a Static Route / BGP routing to a specific site out of a group of WAN routers on the service side  VPN

I can see it using old method  in feature templates (Mark as optional)  But not in the new Configuration Group method.

If i could kindly get a response to this it would be greatly appreciated.

Many thanks in advance

[MHM Cisco World]

use centralized policy and apply it to site-list include all site ID that you want to apply config 
MHM 

[Stevo8300 · Accepted solution]

Hi MHM , 

Many thanks , i get it now 🙂  Traffic Engineering for the Static ,  can also copy configuration groups for example    BranchEdgeServiceSideOSPF  or BranchEdgeServiceSideBGP , then either copy and make a new one as needs be.     Configuration groups used for rapid deployment and to stop template sprawl. Many thanks for you help much appreciated !!

[MHM Cisco World]

You are so welcome 
MHM

[O_A_H]

So, you can't make certain options like static routes as optional, right? Just make another CG with new profile for locations that needs static IPs.. and if you have 1 location with 1 static IP and another location with 4 static IP, then it will end up with big amount of CGs eventually, right?