Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have Cisco 3500 WLC with 2800 APs (8.10.196.0). APs operate in Local mode, so, SSID traffic is central switched. We have a roaming problem. We used 802.1x-FT. With each roaming event, the client will do ARP to the gateway after it finishes. The pr...
A ring network composed of cisco 3650/3850/IE 4040 switches that running REP protocol. How to maintain certain priorities & delay & jitter for traffic types based on VLAN classification? All SVIs are on 3850.
I have installed virtual MSE 8.0 & gave it initial configs. It has network reachability but never opens HTTP or HTTPS. I try to add it on Prime but it fails also. I attached the output of (/etc/init.d/msed status). Any suggestions?
I'm using my virtual WLC 8.0 with ISE 1.3 to make Central Web Auth (CWA). Since the WLC is virtual, the AP is in Flex mode and accordingly any ACL needed to be forced by ISE is Flex ACL. The problem is that whenever i try to add the FlexACL to the AP...
I'm confused about something related to the Optimized Roaming feature in WLC. I understand that it resolves the sticky client issue and will disassociate it if its RSSI or Datarate goes below a certain level. It will also block a client to associate ...
It is not clear to me what are the affected versions that if we upgrade from, we hit this.Does this also hit the 9800 WLC? I assume so as i read this, but to confirm.
No because as per my last tshooting & packet capture, the 1st ARP packet that is lost is not seen on the AP switchport. My OTA was disturbed so i couldn't verify on the air. But it is always the 1st ARP packet get lost (doesn't even reach the switch)...
So, you can't make certain options like static routes as optional, right? Just make another CG with new profile for locations that needs static IPs.. and if you have 1 location with 1 static IP and another location with 4 static IP, then it will end ...
