I'm attempting to setup an SDWAN lab, but it seems that no attempts have been made to establish the control connection between the controllers even after installing the certificate? any suggestion?
Version: 20.9.2.1
Devices Controller:
Devices Certificate:
Configuration:
| vManage |
vBond |
vSmart |
|
system
host-name vManage
system-ip 99.99.99.10
site-id 10
admin-tech-on-failure
no vrrp-advt-with-phymac
organization-name layer3life
clock timezone Asia/Singapore
vbond vbond.local
vpn 0
dns 8.8.8.8 primary
host vbond.local ip 10.110.1.11
interface eth0
ip address 10.110.1.10/24
tunnel-interface
allow-service all
allow-service dhcp
allow-service dns
allow-service icmp
no allow-service sshd
no allow-service netconf
no allow-service ntp
no allow-service stun
allow-service https
!
no shutdown
!
ip route 0.0.0.0/0 10.110.1.254
|
system
host-name vBond
system-ip 99.99.99.11
site-id 10
admin-tech-on-failure
no route-consistency-check
no vrrp-advt-with-phymac
organization-name layer3life
clock timezone Asia/Singapore
vbond vbond.local local vbond-only
vpn 0
dns 8.8.8.8 primary
host vbond.local ip 10.110.1.11
interface ge0/0
ip address 10.110.1.11/24
ipv6 dhcp-client
tunnel-interface
encapsulation ipsec
no allow-service bgp
allow-service dhcp
allow-service dns
allow-service icmp
no allow-service sshd
allow-service netconf
no allow-service ntp
no allow-service ospf
no allow-service stun
allow-service https
!
no shutdown
!
ip route 0.0.0.0/0 10.110.1.254
|
system
host-name vSmart01
system-ip 99.99.99.12
site-id 10
admin-tech-on-failure
no vrrp-advt-with-phymac
organization-name layer3life
clock timezone Asia/Singapore
vbond vbond.local
vpn 0
dns 8.8.8.8 primary
host vbond.local ip 10.110.1.11
interface eth0
ip address 10.110.1.12/24
ipv6 dhcp-client
no shutdown
!
ip route 0.0.0.0/0 10.110.1.254
|
Logs:
vBond# show orchestrator connections-history
vBond#
vManage# show control connections
vManage#
I tried restarting every controller and adjusting the interface-tunnel parameters, but the problem stayed.
Thanks
