Viptela Template out of sync

[StevePercy03261]

Hi,

I are currently facing an issue with an Cisco 1100 SD-WAN  (Viptela) router at a template level. I tried pushing down a template and it is currently throwing out an error. The device template is 'Out-of-Sync'. The device is reachable and up an running, but I cannot currently push out any templates as the old template is still in the queue.

How do put the template back in sync?

Could someone please help me with this?

Thanks

[Amr_Younes]

Are you able to SSH to the device from vManage ?

Could share a screenshot of the error?

[StevePercy03261]

Hi Amr,

Thanks for reaching out. I added a subinterface and tried nto push down a template, but I got an error saying 'Out-of-sync'. Its the feature template that is out of sync. The device is still up and running fine.

Thanks

[Amr_Younes]

You may need to reload the router, also try to detach the template and add the configuration using the CLI and then commit.

If CLI configurations is accepted then try to push the template again

[rafafilho11]

Issue solved, there were a feature template point to the interface that was not existing on the device, I could see it when I removed the device from the template and tried to re-add. After fix the feature template configuration on the Template the message: "Template out of sync" Was cleared.