Hello Guys,I'm planning an update of the QoS policy deployed on the SD-WAN infrastructure. We currently have a hub and spoke topolgy deployed with two edge routers (hub) in each data center. The QoS policy has 5 classes, we need to updtate this polic...
Forum Posts
With SD-WAN, must the vManage, vBond and vSmart all run the same OS version? Or, is it possible to run 19.1.X on vBond and vSmart and 19.2.X on vManage? Thanks!
Hello!I am working with one of our administrators that controls the Cisco Viptela infrastructure. We are following a vendor's configuration recommendation and are seeing a discrepancy between what options we have in vMange (or even the CLI) and what ...
Example:-Vedge1 is unaware of Vedge2's routing information. To the best of my knowledge, vsmart keeps track of all vedge routing information and pushes it to all vedges. Depending on the routing information, data will either travel directly between v...
I would need at least 4 additional SFP ports.
HiI have two internet facing interfaces and both Configured for DIA. I Configured Traffic policy for youtube traffic restricting for one ISP Connection. (BIZ Internet) when both Connections are present youtube Trafic blocked saying Ipv4NoRoute. Contr...
I have been playing with sdwan in eve-ng with the topology below. I already bring up the tunnels and can see both sites up to vpn0 from each other. still getting use to and practicing with templates but i really having difficulties in how to send t...
Hi there,Is there a document which outlines what inbound and outbound ports are required for Cisco Viptela controllers?The intent is for all the remote sd-wan branches to use public internet (without MPLS) to connect to Viptela Controller on public C...
Resolved! NAT DIA Tracker doubt
Hello, I have a doubt about the NAT DIA tracker, if i only configure the dia tracker without the fallback it will monitor the local dia, if internet dia 1 fail nat dia tracker will reroute the traffic to the second internet dia 2? The natfallback is ...
Hello experts, I have configured VPN interface ethernet template with Dynamic IP on interface GigabitEthernet2 interface which belongs to VPN 10. When I apply it to CSR1000v (AWS EC2 or ESXi VM) i get an error: [28-Sep-2022 21:28:11 EEST] Configuring...
We are doing a large SD-WAN deployment and we have created a device access policy only allowing SSH access from certain devices to the vty lines for all SD-WAN routers, all good. Question is how can this be achieved on vmanage/smart/bond. There looks...
what would happen if vsmart goes down as vsmart has OMP peering with Vedges so would Vedge lose its connectivity due to this with other Vedges?
Hi, I have a few vEdges in the warehouse that i would like to update before sending them to the remote site, i would like to download the OS image in a USB flash drive and connect it via the USB port in each vEdge, is there a guide for doing this?. I...
Resolved! sd-wan vmanage
I am unable to find another hdc 100GB in this list, it's showing only one hdc that is 3GB only ...am using this controller in eve-ng , please let me know what could be the issue admin connected from 127.0.0.1 using console on vmanageAvailable storag...
Everyone Would like to understand about the below with respect to OMP & OSPFI am using OSPF as my service side routing protocol & all my vEdge routers are in OSPF Area 0.My understanding is that vEdge advertises the routes it learnt from OSPF via OMP...
