09-06-2019 06:15 AM
Hi All,
I am trying configure vManage cluster, i have two vManage , one vManage already running and i am trying to add new vManage into cluster. i have followed the below:-
sd-wan doc links. still not working
i went to Administration under that cluster management, under service configuration tab :-
clicked on add vManage , it gave me to enter the new vManage ip address and all, have done. says completed, still the second vmanage is not showing,
kindly help me if i am missing anything.
aspa
09-08-2019 08:04 AM
Which interface IP address are you using in vManage for clustering?
Thanks,
Srikanth
09-22-2019 11:23 PM
I am using three interfaces:-
eth0 ---- for VPN 0
eth1--- for OOB(GUI access)
eth2-- for cluster management.
01-24-2020 04:33 AM
Hi There
Are you implementing a vManage Cluster of 2 nodes? Are both vManage in the same L2 network?
01-24-2020 05:25 AM
That is already resolved.
01-24-2020 06:32 AM
Can you tell me which vManage version you are using?
01-24-2020 11:20 PM
08-17-2020 07:18 PM
03-03-2020 12:53 AM
Hi Rohit,
Can You Tell More about the workflow you used for vManage clustering?
best regards,
ehsan
03-09-2020 01:51 AM
09-13-2020 02:06 AM
Hi Rohit,
Yes, I Mean the steps for vManage Cluster Configuration.
Best Regards,
Ehsan
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: