vManage Cluster Configuration Issue

[RohitRaj03827]

Hi All,

I am trying configure vManage cluster, i have two vManage , one vManage already running and i am trying to add new vManage into cluster. i have followed the below:-

sd-wan doc links. still not working

https://sdwan-docs.cisco.com/Product_Documentation/Getting_Started/Viptela_Overlay_Network_Bringup/03Deploy_the_vManage_NMS/06Create_a_vManage_Cluster

i went to Administration under that cluster management, under service configuration tab :-

clicked on add vManage , it gave me to enter the new vManage ip address and all, have done. says completed, still the second vmanage is not showing,

kindly help me if i am missing anything. 

aspa

[Srikanth Reddy Navuluri]

Which interface IP address are you using in vManage for clustering?

Thanks,

Srikanth

[RohitRaj03827]

I am using three interfaces:-

eth0 ---- for VPN 0

eth1--- for OOB(GUI access)

eth2-- for cluster management.

[mindgame71]

Hi There

Are you implementing a vManage Cluster of 2 nodes? Are both vManage in the same L2 network?

[RohitRaj03827]

That is already resolved. 

[mindgame71]

Can you tell me which vManage version you are using?

[RohitRaj03827]

Hi mindgame71,

I have used 19.2.099.

[boythanhdat_2012]

eth2-- for cluster management. >>> Do you add this interface in vpn0 without tunnel?

[Ehsan Momeni Bashusqeh]

Hi Rohit,

Can You Tell More about the workflow you used for vManage clustering?

best regards,

ehsan

[RohitRaj03827]

Ehsan Momeni Bashusqeh,
Workflow means you want to know how to configure vManage cluster or what?

[Ehsan Momeni Bashusqeh]

Hi Rohit,
Yes, I Mean the steps for vManage Cluster Configuration.

Best Regards,

Ehsan