03-09-2011 10:23 AM
For migrating from Vswitch (static 802.3ad) to 1000v, i need to configure ip hash (ip source destination) on the 1000v. The idea is migrate from Vswitch to 1000v WITHOUTH changing the switch configuration).
Is that posible?
Thanks
03-09-2011 02:06 PM
When you create your uplink port profile you simply use the auto channel command in your config:
channel-group auto mode on
This will create a static etherchannel when two or more ports are added to the uplink port profile from the same host. Assuming your upstream switch config is still set to "mode on" for the etherchannel config, there's nothing to change.
Regards,
Robert
03-09-2011 02:12 PM
Hi Robert
When configuring IP hash on a regular Vswitch installation, the load distribution algorithm must be change to source-destination-IP on the uplink switch.
If those ports are now connected to a 1000v, source-destination-IP is not longer supported on the 1000v and must be changed . This is a global configuration and will affect others Vswitches connected to the same switch
What do you think?
- Alex
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide