Server Networking

Hello,We observe that a static default route on a Non-Default VDC pointing to a firewall changes the next hop to the default VDC when the next hop is not reachable. This occurs even the Default VDC is not redistributing or originating a default route...

Hi Guys,Is it possible to create an Active/Active Team from a vmware ESX server, across two seperate 2960's??If so whats the configuration on the switch side / vm side?ThanksScott

Hello - We are running two 7010 set up together as vPC peer.  We have at least 8 or 9 switches connected via vPC with LACP running just fine.  I have three Unix hosts with 10Gig connections.  I have had one connected in a vPC Port Channel (NOT LACP) ...

Hi, Can anyone confirm if the attached topology will work? As long as there is no single point of failure, the solution is accepable. THanks Eng Wee

Hello,in Nexus1000V (4.0(4)SV1(3b) there is a limitation of 1000 mac-adreeses per VLAN per host, see:#################################################################################Maximum Allowed VLANs and MAC Addresses per VLANTable 1-2 lists the ...

I am about to deploy two 5548 nexus switches with two 2248TP fabric extenders. I will connect the 5548’s to each other using the 10Gig SFP+ modules. I will connect the 2248’s in straight through mode so one 2248 will connect to one 5548 and the othe...

Yes, ladies and gentlemen, the old oversubscription dilemma. What to think about when planning a data center deployment...No  doubt it is difficult to come up with a rule of thumb or some canned  answer with regard to OSRs. There are so many variable...

Hello this is kiran,Help me  i have Router 2800 series we are using leased line Connection 8 Pubilc IP.One IP Config in Router FE0/0 IP 101.102.148.91 and FE0/1 192.168.0.0 Local IP.I have 6 Web Server. How to Config other 7 IP address on Web server ...

Hi there,we have recently purchased 2 3110x and installed them on an IBM Blade Center.Switches are running IOS 12.2(52)SE.We want to stack them for aggregating server ports (internal switch ports), as well as configure SoL (Serial over LAN) feature t...

Hello,I have 2 vPCs between a 6509 connected and 2 different N7K 7010 (running 5.1.2), called vPC 100 and 101 on ports e10/26 and e10/27 on each N7K.Consistencies are ok on both sides, my question is what happens if I reboot teh 6509 based on the mes...