7200 with ghost cpa interface

gbarreraoro · ‎01-29-2002

I have a 7200 router with a cpa interface. In show running config can be seen several interfaces channel(interface Channel2/0

no ip address

no ip directed-broadcast

ip mtu 0

!

interface Channel2/0

no ip address

no ip directed-broadcast

ip mtu 0)

There is only cpa instaled.

Anybody have any notice of this?

Thanks

skoretsk · ‎01-30-2002

Hi Gustavo,

I haven't seen that problem before. How are you accessing the CPA router - directly through the console/aux port using a terminal emulator like hyperterm (VT100, etc) from a PC, telnetting into the router, other ways? You might want to try accessing the router in some other way than how you did so when you saw the duplicate interface display. Are you certain you're not just seeing previous output saved in the buffer? Regards, Steve

gbarreraoro · ‎01-31-2002

I'm accessing to the router by telnet, but the same i get accessing by console. There are 3 interface in show run and show start commands.

show startup-config

!

interface Channel2/0

ip address x.x.x.x x.x.x.x

no ip directed-broadcast

no keepalive

csna xxxx xx

max-llc2-sessions 2000

lan TokenRing 0

source-bridge xxx x xx

adapter 0 4200.0000.0024

lan TokenRing 1

source-bridge xxxx x xx

adapter 1 4000.0000.0004

name adap1

tn3270-server

maximum-lus 500

keepalive 65000

unbind-action keep

lu termination termself

pu xxxxxxx xxxxxxx x.x.x.x token-adapter 1 22 rmac 4000.0000.0004 #

pu xxxxxx xxxxx x.x.x.x token-adapter 1 24 rmac 4000.0000.0004 #

!

interface Channel2/0

no ip address

no ip directed-broadcast

ip mtu 0

!

interface Channel2/0

no ip address

no ip directed-broadcast

ip mtu 0

!

Regards.

skoretsk · ‎01-31-2002

Gustavo, this doesn't appear to be normal behaviour at all and I can't think of any operational reason why you would see the same Channel interface displayed 3 times! I recommend you open a case with Cisco TAC so they can troubleshoot the problem and hopefully provide a resolution. Regards, Steve