478
Views
0
Helpful
1
Replies
Blade Switch - Layer 2 Trunk Failover
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-01-2007 02:33 PM
Does anyone know from experience on a 3020 or GESM HP blade switch if downstream ports are recovered automatically when an uplink port recovers from a failure? I have seen references to the downstream ports being put in err-disabled state and was curious if they needed to be recovered manually even after the upstream recovers. Thanks.
Labels:
- Labels:
-
Server Networking
1 Reply 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-07-2007 05:14 PM
Yes, the downstream ports come up automatically when the upstream ports come back active.
