Hi all,
in recent weeks I have tested 9 Cisco Nexus B22DELL extenders in DELL M1000e chassis from 1 supplier, 6 of which have ports 9,10,15,16 stucked in state "Not connected". 3 of 9 fexes had worked fine. I have tried to swap midplane im M1000e but nothing changed.
Test was made by moving uplink from one fex to another and reseating the fex. After the full init verified by sh fex X, I continued by issuing show interfaces fex X commands and moving 4 testing server through the chassis. Ports 9,10,15,16 were not able to detect the server interfaces. Pin on fex connector looks fine.
Am I missing smth or is this a common nexus failure?
Here is the example output of sh fex commands:
https://pastebin.com/z2dJz7e4
Any ideas are greatly appreciated.
Regards,
Peter
