Hyperthreading

[wynneitmgr]

We have two UCSC-C220-M5L servers. I am needing to turn on Hyperthreading. Is there any good documentation or videos out there of the step-by-step process? Thank you!

[Kirk J]

Assuming this is standalone server:

Go CIMC IP address in Web browser:

• Compute, BIOS Tab, Configure BIOS subtab, Processor subtab.

See below picture:

Kirk...

[wynneitmgr]

@Kirk J 

I rebooted my servers and went into CIMC Configuration to see if I could get the CIMC GUI working but I still cannot access CIMC GUI in web browser. Here is my CIMC Configuration.

[Kirk J]

Set the NIC redundancy to none, and NIC mode to dedicated.  Then try accessing via the dedicated port on the back.

Kirk...