I have a requirement to upgrading our UCS 5108 firmware, and I would like to know if there's any gotchas that I should watch out for. since the firmware will be jump upgrading from 2.2(1b) to latest firmware 3.2(2d)
we've a couple of UCS 5108 configured in HA
with mix blade servers (B200 M2 , B230 M1)
installed (Hyper-V , ESXi 5.5 , XenServer) and all blades are boot from SAN (EMC VNX)
as well as Fabric Interconnect (6120xp)
Has anyone have done the upgrades before successfully? without any issue.
sorry but I worry due all the blade servers are in production mode
Good afternoon Friends, these days I was accessing the DNAC manager and my surprise is that I did not have access, after a basic analysis I observed that the equipment was operational, but without being able to access it via DNA GUI (browser) I also ident...
Today we are going to talk about how to configure backups in the Cisco ACI APIC Dashboard. As you might know APIC is a UCS based CIMC controller and we can check the configuration backups on the Cisco ACI APIC Dashboard. Remember that the HA solution mus...
Listen: https://smarturl.it/CCRS9E14 Follow us: https://twitter.com/CiscoChampion
Organizations are undergoing digital transformation like never before. Global spending on digital transformation of business practices, products, and organization...