Hi guys,
I am searching for an appropriate command to watch the port utilization of my N5k ethernet ports.
The "show interface eth1/x" just gives me the input and output rate for a port as a 5 minute average.
If possible I need updates every few seconds.
Is there any possibility to achieve this without NetFlow?
This is how it is done on a Fujitsu switch:
c221cb5 config2# show ether utilization
Port TX/sec Util RX/sec Util
------ ---------- ------- ---------- -------
1 106695 17 6271 0
2 103983 17 6145 0
3 130984 21 7705 0
4 107058 17 6299 0
5 130955 21 7704 0
6 106936 17 6290 0
7 107604 17 6310 0
8 71214 11 4187 0
9 106647 17 6267 0
10 102444 17 6030 0
11 82246 13 4839 0
12 106059 17 6237 0
13 82169 13 4833 0
14 106137 17 6245 0
15 104376 17 6140 0
16 70073 11 4116 0
17 71864 12 4224 0
18 3 0 0 0
19 18107 0 176720 29
20 20267 0 189597 31
21 0 0 237115 38
22 6266 0 202088 33
23 17124 0 175758 28
24 16603 0 209613 34
25 9063 0 210456 34
26 12436 0 295644 48
C1 2 0 3 0
Any help is appreciated!
Thanks a lot!
