NTP CONFIGURATION

[aslam mohammad]

Hi All,

I am trying to change Ntp server IP address in N5548 switch But it is not updating with new IP.please find the attached screenshot for your reference.

Regards

Aslam

[Victor Acevedo · Accepted solution]

Hey Aslam,

You will need to do the following in order to make changes to your NTP configurations:

(config)# clear ntp session 
(config)# no ntp distribute 
(config)# ntp server x.x.x.x << add or remove any new NTP server

Thanks,

Victor Hugo Acevedo

[aslam mohammad]

Hi victor,

Thanks For your reply.

Now its working also updated with new IP

What is the use of ntp distribute command.

[Victor Acevedo]

Hey Alsam,

Sounds good. The 'ntp distribute' command is used to distribute the NTP configurations using Cisco Fabric Services or CFS to other CFS-enabled devices. 

Thanks,

Victor Hugo Acevedo