SNMPv3 encryption

[Steven Williams]

Why is this command not working?

Enforce on each user says no

N5k1(config)# snmp-server globalEnforcePriv
NASSWN5k1(config)# show snmp user
______________________________________________________________
SNMP USERS [global privacy flag enabled]
______________________________________________________________

User Auth Priv(enforce) Groups
____ ____ _____________ ______
admin md5 des(no) network-admin

netserv md5 des(no) network-admin

DC@dmin sha aes-128(no) network-operator

______________________________________________________________
NOTIFICATION TARGET USERS (configured for sending V3 Inform)
______________________________________________________________

User Auth Priv
____ ____ ____
N5k1(config)# 

[Kirk J]

Greetings.

#show snmp user

only shows the configuration for the current user, not the global configuration mode.

It appears this is by design, and likely applies to both N5k and N7K.

Thanks,

Kirk...

[Steven Williams]

How do you verify that user enforce is enabled then?