Try upgrade IOS-XR from 4.3.4 to 6.4.2. But during install i got error message:
RP/0/RSP0/CPU0:M9-ASR02(admin)#show install log 28 detail
Mon Sep 24 15:50:30.125 MSK
Install operation 28 started by user 'alex' via CLI at 15:43:03 MSK Mon...
We started to use in production new NCS5504.
We have no any L3VPN installed because we don't use MPLS. We have only 2 VRF instances.
From this document https://www.cisco.com/c/en/us/products/collateral/routers/network-convergence-syste...
Hi Dear Firend When Active subscriber Ip routed in interface for ISG layer 3
when user want access to newtwok in DMZ ISG drop packet isg block Ip address Off users Recieve traffic
when send user Packet Form the network to the internet ISG unblock A...
i would like to leak a route locally from vrf to another without passing it to other vpnv4 neighbors.
For example: i have two PEs and one P RR. On both PEs i have the same VRF (vrf A) with same RT (for example Import 1:1 and export 1:1). On both PE...
I was playing around a little bit with the new ASR9901 running the 6.4 version and I noticed that the command "monitor interface XXX" which previously was showing the packet/byte rate is not available anymore. I have tried to lookup int...