This event had place on Tuesday 19th, March 2019 at 10hrs PDT
This event provides an introduction to Segment Routing (SR) and its simplicity for MPLS data plane forwarding in Cisco IOS® XE and Cisco IOS XR. There are a variety of MPLS applications, which are built over multiple control plane protocols with complex interactions. Label Switch Paths (LSPs) have been traditionally provisioned with protocols such as LDP, TDP, RSVP-TE, and BGP-LU. The session includes a live demonstration of configuration examples and other best practices.
Label distribution overview
MPLS applications over SR
Elvin Arias Soto is a Customer Support Engineer with the Cisco IOS XR team in Cisco’s Customer Experience organization. He has experience across different technologies such as OSPF, BGP, IS-IS, EIGRP, Cisco IOS XR, DMVPN, MPLS, and multicast among others. Elvin holds a bachelor’s degree in information technology from the Iberoamericana University of the Dominican Republic. He has several Cisco certifications, such as CCIE R&S #57406, CCNP R&S, CCNA Service Provider, CCNA Security, and CCNP SP. He is currently preparing for the CCIE Service Provider certification. In addition, the Cisco Learning Network community has selected him as a Cisco Designated VIP for five years in a row (since 2013).
I'm on Cox Cable in Phoenix and I have three Cisco STA1520 tuning adapters. In July of 2020 something happened and my tuning adapters started rebooting several times a day. When this happens it cancels my recordings and interrupts my feed for ...
In simple terms, 'Route Churn' is defined as the 'rate of change of prefixes'. Different XR versions across 4.x to 7.x have differing behavior & support for the BGP churn handling and some enhancements made from 6.5.3 onwards (listed in appendix) mak...
Hi Community, We have an ASR9K facing a problem to display the interfaces statistics, when typing a show command like "show ipv4 int brief" or "show interfaces interface-id" or any other command to show an interface information or statistic, no info ...
Hi All, Just need some help with my DHCP realy config on Cisco NCS540 running XR 7.1.1 Actually i was using Huawei switch before and below are the configs on Huawei for the DHCP. interface Vlanif20description 1st NNI - Voice Vlanip address ...
Hi I'm trying to configure a EoMPLS on 2 different router and enable traffic on a VRF.So what I want to do is:R1----R2----R3 R1 is on a Routing Area and R3 is on another one, all three Router know each other witch OSPF.The traffic from R3 come on my ...