Question
Hello Gents,
Kindly, I have an IOS-XR 9K device, which the port HundredGigE0/3/0/0 is not becoming UP and remains down.
This is the IF-CONFIG:
interface HundredGigE0/3/0/0
cdp
mtu 9200
lldp
enable
!
transceiver permit pid all
I tried the "transceiver permit pid all" command as above and it's not working.
Note that it's connected to another IOS-XR device. and we tried to change the SFP in addition to Patch cords and the same issue.
Also, check the below please:
sh controllers Hu0/3/0/0
Tue Oct 17 12:21:52.791 UTC
Operational data for interface HundredGigE0/3/0/0:
State:
Administrative state: enabled
Operational state: Down (Reason: Remote fault with no detail)
LED state: Red On
Phy:
Media type: R fiber over 4 Lane optics (long reach)
Optics:
Vendor: xxx
Part number: FTLC1182RDNS-J3
Serial number: UR10MC0
Type: 740-032210 REV 0
Rev: N/A
Wavelength: 814.675 nm
Digital Optical Monitoring:
Transceiver Temp: 38.761 C
Transceiver Voltage: 3.261 V
Alarms key: (H) Alarm high, (h) Warning high
(L) Alarm low, (l) Warning low
Wavelength Tx Power Rx Power Laser Bias
Lane (nm) (dBm) (mW) (dBm) (mW) (mA)
-- ----- ------ ------ ------ ------ ------
0 n/a 0.6 1.1452 -0.1 0.9698 64.604
1 n/a 0.1 1.0330 0.7 1.1719 88.654
2 n/a 0.7 1.1779 -0.1 0.9779 71.128
3 n/a 0.5 1.1115 0.1 1.0233 83.666
DOM alarms:
No alarms
Alarm Alarm Warning Warning Alarm
Thresholds High High Low Low
------- ------- ------- -------
Transceiver Temp (C): 70.000 68.000 2.000 0.000
Transceiver Voltage (V): 3.465 3.432 3.168 3.135
*This is from my side
--------------------------------
*This is from the peer side
Also, note that we have another HunG port which are working fine.
Please, your support would be appreciated.
