Hi,
I am trying to console to another router connected via a aux port. Following is my setup
R1(aux port)------------>R2(console port)
--------------------------------------------------------------------------
On R1
following is the aux port configs
line aux 0
modem InOut
no exec
transport preferred telnet
transport input all
transport output all
interface Loopback1
ip address 1.1.1.1 255.255.255.255
sho line output
Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int
0 CTY - - - - - 0 30 0/1554 -
* 1 AUX 0/0 - inout - - - 1 0 0/0 -
3 TTY - inout - - - 0 0 0/0 -
--------------------------------------------------------------------------------------------------------
i try to telnet into R2 on loopback1 address port 2001
Following is the result
R1#telnet 1.1.1.1 2001
Trying 1.1.1.1, 2001 ...
% Connection refused by remote host
Please check to see if i have missed anything.
i also note that the console port is also the aux port on Cisco891F
