I have been trying to get IPSec VPN access on our internet facing router without success for over a month now. Please can someone help.   Our internet router is CISCO881-SEC-K9 , Cisco IOS Software, C880 Software (C880DATA-UNIVERSALK9-M), Version 15.2(4)M3, RELEASE SOFTWARE (fc2) I am using Cisco VPN Client Version 5 for the remote access dial up.   I have run the debugs debug crypto isakmp debug crypto isakmp error debug crypto ipsec        debug crypto ipsec error     Attached are the debug results   I have the same configs working through our other internet link   ... View more

Hi, I suspect my router is having high cpu utilization as response to ssh and telnet is slow, also response to execute commands is slow. I did a "show processes cpu sorted 5min" Can anyone please explain the results of the "show processes cpu sorted 5min" I have uploaded the results in the attachements. kind regards Dan ... View more

Hi, I am trying to console to another router connected via a aux port. Following is my setup R1(aux port)------------>R2(console port) -------------------------------------------------------------------------- On R1 following is the aux port configs line aux 0  modem InOut  no exec  transport preferred telnet  transport input all  transport output all interface Loopback1 ip address 1.1.1.1 255.255.255.255 sho line output  Tty Typ     Tx/Rx    A Modem  Roty AccO AccI   Uses   Noise  Overruns   Int       0 CTY              -    -      -    -    -      0      30     0/1554    - *     1 AUX      0/0     - inout     -    -    -      1       0     0/0       -       3 TTY              - inout     -    -    -      0       0     0/0       - -------------------------------------------------------------------------------------------------------- i try to telnet into R2 on loopback1 address port 2001 Following is the result R1#telnet 1.1.1.1 2001 Trying 1.1.1.1, 2001 ... % Connection refused by remote host Please check to see if i have missed anything. i also note that the console port is also the aux port on Cisco891F ... View more

Hi, I am trying to console to another router connected via a aux port. Following is my setup R1(aux port)------------>R2(console port) -------------------------------------------------------------------------- On R1 following is the aux port configs line aux 0  modem InOut  no exec  transport preferred telnet  transport input all  transport output all interface Loopback1 ip address 1.1.1.1 255.255.255.255 sho line output  Tty Typ     Tx/Rx    A Modem  Roty AccO AccI   Uses   Noise  Overruns   Int       0 CTY              -    -      -    -    -      0      30     0/1554    - *     1 AUX      0/0     - inout     -    -    -      1       0     0/0       -       3 TTY              - inout     -    -    -      0       0     0/0       - -------------------------------------------------------------------------------------------------------- i try to telnet into R2 on loopback1 address port 2001 Following is the result R1#telnet 1.1.1.1 2001 Trying 1.1.1.1, 2001 ... % Connection refused by remote host Please check to see if i have missed anything. i also note that the console port is also the aux port on Cisco891F ... View more

I am unable to Unable to make inbound and outbound calls on SIP trunk. My deployment scenarios is as follows; IPPhone>>>>>>CUCMv11>>>>>>CUBE(CISCO2911/K9) IOS Version 15.4(3)M5>>>>>>>SBC/ITSP SIP trunk from CUCM to CUBE is up, calls getting to CUBE but not going outbound and inbound calls. sip-ua register status# Line               peer         expires(sec)     reg           survival       P-Associ-URI ================================ ========== ============ === ======== ============ 79999662       -1             172                 no             normal following is my current configuration on the CUBE pngasl-uc-router#sho run Building configuration... Current configuration : 6099 bytes ! ! Last configuration change at 13:25:20 GMT Wed Oct 26 2016 by x ! NVRAM config last updated at 12:58:16 GMT Wed Oct 26 2016 by x ! version 15.4 service timestamps debug datetime msec service timestamps log datetime msec service password-encryption ! hostname x ! boot-start-marker boot-end-marker ! ! card type e1 0 0 logging buffered 12288 ! no aaa new-model clock timezone GMT 10 0 network-clock-participate wic 0 network-clock-select 1 E1 0/0/0 ! ! ! ! ! ! ! ! ! ! ! ! ! ! ip domain name x.x.x ip name-server 8.8.8.8 ip name-server 192.168.40.30 ip name-server 192.168.40.31 ip cef no ipv6 cef ! multilink bundle-name authenticated ! ! ! ! ! isdn switch-type primary-net5 ! cts logging verbose ! ! voice-card 0 dspfarm dsp services dspfarm ! ! ! voice service voip ip address trusted list ipv4 x14.91.29 ipv4 x.x.0 255.255.255.0 ipv4 x.x.70.5 ipv4 x.x.70.6 no notify redirect ip2ip allow-connections h323 to h323 allow-connections h323 to sip allow-connections sip to h323 allow-connections sip to sip no supplementary-service sip moved-temporarily no supplementary-service sip refer fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback none sip bind control source-interface GigabitEthernet0/0 bind media source-interface GigabitEthernet0/0 outbound-proxy dns:x.x.xom no update-callerid ! voice class codec 1 codec preference 1 g711alaw codec preference 2 g711ulaw codec preference 3 g729r8 ! voice class codec 2 codec preference 1 g729r8 codec preference 2 g711alaw codec preference 3 g711ulaw ! ! ! ! ! ! voice translation-rule 103 rule 1 /^6../ /79999662/ rule 2 /^7../ /79999662/ ! voice translation-rule 105 rule 1 /79999662/ /600/ ! ! voice translation-profile INBOUND-SIP-TRANSLATIONS translate called 105 ! voice translation-profile OUTBOUND-SIP-TRANSLATIONS translate calling 103 ! ! ! license udi pid CISCO2911/K9 sn FGL202010A2 hw-module pvdm 0/0 ! ! ! ! redundancy ! ! ! ! ! controller E1 0/0/0 framing NO-CRC4 pri-group timeslots 1-31 ! controller E1 0/0/1 ! ! ! ! ! ! ! ! ! ! ! interface Embedded-Service-Engine0/0 no ip address shutdown ! interface GigabitEthernet0/0 description ---H.323 Gateway---- ip address x.x.x.x 255.255.255.0 duplex auto speed auto h323-gateway voip interface h323-gateway voip bind srcaddr x.x.70.254 ! interface GigabitEthernet0/1 no ip address no ip redirects no ip unreachables no ip proxy-arp duplex auto speed auto pppoe enable group global pppoe-client dial-pool-number 1 no cdp enable ! interface GigabitEthernet0/2 no ip address shutdown duplex auto speed auto ! interface Serial0/0/0:15 no ip address encapsulation hdlc isdn switch-type primary-net5 isdn incoming-voice voice no cdp enable ! interface Dialer1 ip address negotiated no ip redirects no ip unreachables no ip proxy-arp ip mtu 1452 ip flow ingress ip virtual-reassembly in encapsulation ppp dialer pool 1 dialer-group 1 ppp authentication chap pap callin ppp chap hostname  ppp chap password  ppp pap sent-username password  no cdp enable ! ip forward-protocol nd ! no ip http server no ip http secure-server ! ip route 0.0.0.0 0.0.0.0 Dialer1 ip route 192.168.0.0 255.255.0.0 192.168.70.1 ip ssh version 1 ! ! ! ! control-plane ! ! voice-port 0/0/0:15 bearer-cap Speech ! voice-port 0/1/0 ! voice-port 0/1/1 ! voice-port 0/1/2 ! voice-port 0/1/3 ! ! ! ! ! mgcp behavior rsip-range tgcp-only mgcp behavior comedia-role none mgcp behavior comedia-check-media-src disable mgcp behavior comedia-sdp-force disable ! mgcp profile default ! sccp local GigabitEthernet0/0 sccp ccm 192.168.70.5 identifier 1 priority 1 version 7.0 sccp ccm 192.168.70.6 identifier 2 priority 2 version 7.0 sccp ! sccp ccm group 1 bind interface GigabitEthernet0/0 associate ccm 1 priority 1 associate ccm 2 priority 2 associate profile 1 register CONFERENCE ! ! ! dspfarm profile 100 transcode codec g729abr8 codec g729ar8 codec g711alaw codec g711ulaw codec g729r8 codec ilbc maximum sessions 3 associate application SCCP shutdown ! dspfarm profile 1 conference codec g729br8 codec g729r8 codec g729abr8 codec g729ar8 codec g711alaw codec g711ulaw maximum sessions 3 associate application SCCP shutdown ! dial-peer voice 1 voip destination-pattern 79999662 session protocol sipv2 session target ipv4:192.168.70.5 incoming called-number 79999662 dtmf-relay rtp-nte codec g711ulaw no vad ! dial-peer voice 100 voip destination-pattern 0.T session protocol sipv2 session target dns no voice-class sip outbound-proxy voice-class sip bind control source-interface GigabitEthernet0/0 voice-class sip bind media source-interface GigabitEthernet0/0 dtmf-relay rtp-nte codec g711ulaw no vad ! dial-peer voice 600 voip destination-pattern 6.. session target ipv4:192.168.70.5 incoming called-number 6.. dtmf-relay h245-alphanumeric codec g711ulaw ! dial-peer voice 700 voip destination-pattern 7.. session target ipv4:192.168.70.5 incoming called-number 7.. dtmf-relay h245-alphanumeric codec g711ulaw ! ! sip-ua credentials username 79999662 password 7realm pom-sbc.digicelpng.com authentication username 79999662 password 7 realm pom-sbc.digicelpng.com no remote-party-id retry invite 2 retry register 10 timers register 250 registrar dns: expires 3600 sip-server dns:x..x.com ! ! ! gatekeeper shutdown ! ! ! line con 0 logging synchronous login local line aux 0 line 2 no activation-character no exec transport preferred none transport output pad telnet rlogin lapb-ta mop udptn v120 ssh stopbits 1 line vty 0 4 login local transport input all ! scheduler allocate 20000 1000 ntp master ntp server 103.242.68.69 ! end ... View more

I need help accessing the embedded AP on this router Cisco C867VAE-W-A-K9. I am using the int vlan 1 ip to console into the embedded ap on port 2002. i have tried this credentials admin/admin, cisco/cisco and Cisco/Cisco but no luck. Anyone had similar issue and fixed it? ... View more