Please be advised, the GuideMe Wizard is no longer available on the Small Business Support Community. For search capability please use the community search field to find content related to Cisco Small Business documents, videos, and discussions.
The only time you would need SIP-B and "CFWD Notify Serv" set to Yes is if one of the following are true:
Phone registers to a SPA9000 IP PBX
Phone registers to Sylantro
Do not enable either SIP-B or CFWD Notify Serv if you are using Broadsoft or any other third-party call control aside from a Linksys SPA9000 or Sylantro.
If you do enable the above, you will see SIP SUBSCRIBE "missed-call-summary" messages being sent. These messages are not of use to Broadsoft or any other third-party call control besides the SPA9000 and Sylantro platforms.
Hi! I just bought an SG 200-08 switch to split my Internet connection in two vlans where one (apartment) has 100Mb/s and the other vlan (my place) has the rest of the 500Mb/s connection and the apartment devices should not be able to see my devices and vi...
Hi Guys, mi name is Pablo, and i have 2 Cisco RV345, in Firmware Version 1.0.01.20, and the same configuration in 2 routers (changgin only segment ip).I have a link point to point in port 16, for connect 2 branch offices.I crate a route static for vlans a...
I Have 5 spa 525g2 phones and they have a preset ”custom”firmeware fore Telavox, factory reset does not work, it only returns to custom firmware after 5min, i have tried to uppgrade firmeware but stil coes back to ”custom” firme ware, i need to load ...