02-15-2022 05:16 AM
Hello,
the Cisco CBS250 series is a plague.
Now, I have anther problem that I couldn´t solve.
I have a working output ACL assigned to a port where a camera is connected. Works so far good, until I reboot the camera.
The whole traffic is blocked by the switch until I remove my ACL and re-assign it.
I can´t explain why this happen? This behavior is senseless
02-15-2022 05:33 AM
- Check firmware version , use latest - if applicable.
M.
02-15-2022 06:08 AM
There is no difference between 3.0.0.69 and 3.1.1.7 (latest).
Same configuration is working flawless with a C1000. Something is different on the CBS250 series.
02-15-2022 06:24 AM
I swapped the firmware 2 times and now all works like expected!
These kind of problems costs me a lot of my lifetime...
But in future we will keep off our hands from this serie and move back to Cisco Catalyst.
@marce1000, thank you for your help. :top:
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide