Hello All,I need your help to find out the root cause in my SDA topology configuration pushed via DNAC.I have a switch that acts as a border and control node and another switch which acts as an edge node. The issue I am facing that user networks not ...
-
-
-
-
This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community
-
Forum Posts
Hello, I'm using Cisco DNA version System 1.2.0.1013 with Assurance version 1.3.1.140, about data Wired client , all informations are available under assurance>Health but for the Wireless client I don't have any information.The Wireless Controller...
I encountered a problem on DNAC. It reports connectivity to 10.30.5.131 is down. In fact, this IP address is my DNAC IP address. Secondly, in the system 360, I capture this screen for my DNAC. It said NodeStatusUnknown, Kubelet stopped posting node...
Hello, I have a design and best practice question. I'm working with a customer to help build out an SDA environment. With respect to SDA design recommendations and best practices, all clients should be DHCP-based leveraging address pools. However, ...
Resolved! Effect of switch removal from the Fabric
What would be the effect of removing a switch from the fabric in DNAC ? will it perform normally if we discovered it and added it to the fabric again ? What is the correct procedure to remove the switch from the fabric ? in my case I released all po...
Hi all: One of our customer is thinking to implement SDA into their network but still some doubts for IoT (OT) deployments due to multicast/broadcst traffic. Let me elaborate. These are the requirements from customer 1.- IOT PLC devices use b...
Hello,I have two catalyst 9500 planed to act as SDA border / Control plane nodes.My question can i connect some traditional legacy switches ( 2960x , 3650 ) and configure them using CLI traditional method ( L2 trunks ) on the same border nodes while ...
I already have borders provisioned and fabric enabled with a few L3 handoffs.Now i've created two new VN's but they doesn't appear under the border configuration and the interface where i want to add the additional handoffs? What i can recall, i've s...
I am looking to find out if it's possible to use a Cisco 1941 Series router as a thin device for a Software Defined Network.
Hi, We are designing an SD Access solution for a customer site that involves less than 100 endpoints, as a starting point. Customer would like to go for very small design using Fabric-in-the-Box. In the future, customer wants to add redundancy to t...
Resolved! Nexus 7700 as a Border Node
Hi folks, The SDA Compatibility Matrix calls out that the Nexus 7700 SUP2E/3E with M3 line cards can be used as an external border node only. In 1.3 when you configure a border node you then select internal, external, or both. Does the N7700 support...
Resolved! Host Onboarding Vlan ID Modification
Hi, I would like to know if it is possible to modify the vlan ID assigned dynamically when host onboarding provisioning is configured. if it is possible, i would like to know how i can do it. Br, Fidel Gonzalez
Hello, Can you please unicast me where I can find out any Ansible playbooks created to speed up activities related to DNA Centerto install , set-up or other activities
Hello,Is their any option to deploy SD-Access solution as traditional layer 2 without fabric or underlay.If yes, does the DNA-Center will fit in the solution and what are the benefit and feature that i can get from e.g (Discovering devices, provision...
Hello,I have two catalyst 9500 planed to act as SDA border / Control plane nodes.My question can i connect some traditional legacy switches ( 2960x , 3650 ) and configure them using CLI traditional method ( L2 trunks ) on the same border nodes while ...
