Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello
I will to connect a ForcePoint WebSense to CAT6500 with SUP-2T and IOS 15.5, searching information about the configuration I only found an old cisco documentation on 6500 with SUP 720 and older with IOS 12.x.
https://www.cisco.com/c/en/us/supp...
I facing a situation when the client navigate and all the traffic comming is forwading to the switch core and then to firewall and this is forwarding to appliance ForcePoint "WCCP" to apply a NAT and back the flow to the firewall again by other port ...
Hi I client did a ios-xe upgrade from gui but accidentally he loaded a version to c9200. The switch is not reload it yet, so we want to know what is the correct process to do a rollback. I found this command request platform software package install ...
HiI'm confused about what is the best procedure to replace a failed SUP2T-10G on VSS because I founded 2 ways: 1°- Replace the failed SUP-Copy the Same IOS on the new SUP-Configure the VSS: Spoilerswitch virtual domain 100switch 1 priority 200!interf...
Hi Recently upgrade to 16.6.7 but when I wants to create object-group the command it not valid. The switch have IPServicesk9 packages. SpoilerSW1(config)#object-group network my-network^% Invalid input detected at '^' marker.SW1(config)#object-group ...
Hi OK, I validated the command is applied ip http client source-interface GigabitEthernet0/0/1 Do you know if is mandatory to have a contract support to register the ISR4431? Because the syntaxis to call-home has been validated with other devices and...
HiI just post the output, to shows you how appear the flash accordingly your request. Post the complete output to the command "dir flash-1:". I will schedule a MW to apply the command request platform software package clean switch all. Thanks and reg...
