cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2410
Views
0
Helpful
2
Replies

DNAC and Cat9300 Provisioning error

Harish Chopra
Cisco Employee
Cisco Employee

Error - Unable to push CLI 'ip domain-lookup' to device 10.10.10.20  using protocol ssh2

 

I am trying to provision the cat 9300 for the first time in DNAC, it is throwing the error related to ip domain-lookup

Device Model - Cat9300-24U
DNA Center version 1.2.10


I have enabled -
Ssh version 2
generated the crypto key

1 Accepted Solution

Accepted Solutions

Harish Chopra
Cisco Employee
Cisco Employee
Hi, This got resolved after the image was downgraded on the Cat9300. Earlier I installed the latest image - cat9k_iosxe.16.11.01.SPA.bin and this image had bugs which will work with DNAC 1.3 version in the coming release. As of today, the recommendation on the following page was to use 16.09 image. (cat9k_iosxe.16.09.03.SPA.bin) compatibility matrix - https://www.cisco.com/c/en/us/solutions/enterprise-networks/software-defined-access/compatibility-matrix.html After the downgrade, this worked flawless.

View solution in original post

2 Replies 2

Harish Chopra
Cisco Employee
Cisco Employee
Hi, This got resolved after the image was downgraded on the Cat9300. Earlier I installed the latest image - cat9k_iosxe.16.11.01.SPA.bin and this image had bugs which will work with DNAC 1.3 version in the coming release. As of today, the recommendation on the following page was to use 16.09 image. (cat9k_iosxe.16.09.03.SPA.bin) compatibility matrix - https://www.cisco.com/c/en/us/solutions/enterprise-networks/software-defined-access/compatibility-matrix.html After the downgrade, this worked flawless.

Review Cisco Networking for a $25 gift card