Software-Defined Access (SD-Access)

Hello everyone, I have a question about DNAC that needs to be consulted. There are multiple Catalyst 9500 switches in the network. They are configured through DNAC to allow multiple switches to have the same distributed gateway address (for example, ...

Hello Need to know the right order when using  DNA Autolan to build the underlay .Is it to build the switch stack completely and then it will be discovered as a single entity during autolan process ? or do I need to connect one switch to the fabric a...

SD-AccessAs per the documentation that you can implement DNAC either as a single appliance or in HA of three appliances. My question is how will the deployment be in case I have two DNAC appliances. In my BoQ I have 2 x DN2-HW-APL.I couldn't find any...

I have installed DNAC and try to register my 9300 using smart license. however i receive the log below. SLRegistration: Device registration unsuccessful with CSSM. Failure Reason: Device registration is pending for more than 60 seconds, please check ...

Hello Everyone, I am trying to integrate the Embedded WLC with Catalyst 9300 switch but i am unable to do the same.I tried to upgrade the switch with 16.10.1 IOS version and I also upgraded the switch with 16.10.1 Wireless package  as well but I am g...

Hello, I have a customer with 150 branches plus HQ, so, fabric-in-a-box sounds ok for those sites.The WAN today IPSec based (no SD-WAN at all) and is not meant to be used as an IP Transit.As per the title of this post, will each branch be a Fabric Do...

Error - Unable to push CLI 'ip domain-lookup' to device 10.10.10.20  using protocol ssh2   I am trying to provision the cat 9300 for the first time in DNAC, it is throwing the error related to ip domain-lookup Device Model - Cat9300-24UDNA Center ver...

Please take a look at the below question about SNMP configurations in SDA env. [Question] After provisioning a device from DNAC, all types of SNMP traps are enabled on the device. Is it supported to disable unnecessary types of traps individually fro...

Hi Team, I am working on a customer scenario and trying to proposed SD-Access Solution, after reading several articles, i understand fusion router is required depending upon the situation if need to have communication between VRF and GRT or between h...

hi,   Is it supported to daisy chain an SDA edge node behind a fabric in a box 9300? If so, any documentation to forward to the customer? Thanks Gert

Hi Experts, Could you let me know the recommended iBGP connection establishment for Distributed Border Redundancy (Control Nodes are separated from Border Nodes) ? [Question] I understand that Collocated Borders need to establish iBGP connection (per...