cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
682
Views
4
Helpful
5
Replies

sda lisp MAC registration inconsistency

Guys
noticed "amber" output on one of FIABs. Any idea on how to drill down to root cause on that single "MAC registration inconsistency" pls?

FIAB1#show lisp site summary
----------- IPv4 ----------- ----------- IPv6 ----------- ----------- MAC -----------
Site name Configured Registered Incons Configured Registered Incons Configured Registered Incons
site_uci 15 29 0 0 0 0 10 38 1

Site-registration limit for router lisp 0: 0
Site-registration count for router lisp 0: 67
Number of address-resolution entries: 43
Number of configured sites: 1
Number of registered sites: 1
Sites with inconsistent registrations: 1
IPv4
Number of configured EID prefixes: 15
Number of registered EID prefixes: 29
MAC
Number of configured EID prefixes: 10
Number of registered EID prefixes: 38

5 Replies 5

jedolphi
Cisco Employee
Cisco Employee

Hi Andy, this might require a longer investigation than is practical on a forum, in which case you'll need a TAC case, show techs, etc. FYI.

Is the site comprised of just one FIAB, or is there other fabric nodes too e.g. another BN, another EN, etc. What IOS XE versions?

Hi Jerom
thanks for input. SW is 17.10.01 & it's single stack-wise switch on the site (though we have another FIAB w/ couple of xFNs in other site with the same output). both site are just after migration & we already asked Cisco migration team about it. i'll update tread asap.

jedolphi
Cisco Employee
Cisco Employee

Hi Andy. I spoke to the dev team about this, they'll need a TAC case with a "show tech lisp" attached please. Cheers, Jerome

Hi Jerom

sent SR# in private. thanks for your support.

interim update (src - TAC): with existing commands it's not possible to drill down to src of inconsistencies.
case is escalated to BU

Review Cisco Networking for a $25 gift card