cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
866
Views
0
Helpful
1
Replies

5010 in fcoe-npv

tpahuja
Level 1
Level 1

Folks,

           When I enable fcoe-npv feature on my 5010, I notice that it does not recognise fc ports on my expansion slot.

2    8      4x10GE + 4x1/2/4G FC Module      N5K-M1404              ok

when I enable fcoe and npv individually then it recognises the FC modules. Is the behavious the same on 5548s?

Any help would be highly appreciated.

1 Reply 1

Daniel Laden
Level 4
Level 4

This is probably expected behavior.  The FCoE-NPV license is only for FCoE.  The would not include FC ports.

Enabling FCoE NPV

http://www.cisco.com/en/US/docs/switches/datacenter/nexus5000/sw/san_switching/503_n2_1/Cisco_n5k_nxos_sanswitching_config_guide_rel503_n2_1_chapter6.html#task_3173F5B59F604137A1F9C2775A24747C

You can enable FCoE NPV using the feature fcoe-npv  command. We recommend this method in topologies that include all FCoE  connections. A write erase reload does not occur when you use this  method and a storage service license is not required. Enabling FCoE NPV  using the feature fcoe-npv command requires an installed FCOE_NPV_PKG  license.

Thank You,

Dan Laden

Cisco PDI Data Center

Want to know more about how PDI can assist you?

http://www.youtube.com/watch?v=4BebSCuxcQU&list=PL88EB353557455BD7

http://www.cisco.com/go/pdihelpdesk

Review Cisco Networking for a $25 gift card