Alias Rename Not Saving
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-09-2010 06:12 PM
Hi,
I am trying to rename a device alias on and MDS 9000 series SAN Core Switch in Fabric Manager. When I click on it to make the change, it takes it. Then I save it. When I exit out and come back in, the change is new name change reverts back to the original.
When I change the name, the new name is bolded so I know it's a case where a change has been made but not applied.
Any ideas on what I'm doing wrong?
Thanks
- Labels:
-
Storage Networking
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-12-2010 03:20 AM
Is it the same from the CLI? Do you get prompted to save the changes when
you exit Fabric Manager?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-13-2010 10:46 PM
Hello,
Please ensure you are committing the changes before you exit.
to view pending changes from CLI
Switch#show device-alias pending-diff
Thanks,
Prateek
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-15-2010 07:48 AM
Thanks for the replies...
Will try the CLI and let you know how it turns out.
Ed
