cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
317
Views
0
Helpful
1
Replies

cisco 6500 port-channel configuration to connect a UCS-B series

Mohamed Sayed
Beginner
Beginner

hi all,

 

I have two cisco 6513 sup 2T configured as VSS and I need to connect a UCS b-series to this VSS using two physically ports configured as port-channel

i tried all modes of the port channel, no mode made the portchannel up except "mode passive" but after the portchannel is up on passive mode there is one physical port was flapping.

 

how can I solve this problem, please advice ?

 

thanks in advance 

1 Accepted Solution

Accepted Solutions

Vincenzo Errante
Beginner
Beginner

Port Channel passive mode is correct,

but you must use one Port Channel for each FI 

If this is correct check your cabling connection

 

regards

 

View solution in original post

1 Reply 1

Vincenzo Errante
Beginner
Beginner

Port Channel passive mode is correct,

but you must use one Port Channel for each FI 

If this is correct check your cabling connection

 

regards

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers