Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
394
Views
0
Helpful
2
Replies

Connect to ad MDS 9000 family

lorenzochioffi
Level 1
Level 1

‎07-04-2014 08:23 AM

Can i connect to mds9000 family with putty an ethernet cable and the default ipv4 (if exists)?

Labels:
0 Helpful
2 Replies 2

SANTHOSHKUMAR SARAVANAN
Level 4
Level 4

‎07-04-2014 08:27 AM

Hi , 

 Yes you can login . 

Management Interface

 

The management interface allows multiple simultaneous Telnet or SNMP sessions. You can remotely configure the device through the management interface (mgmt0), but first you must configure some IP parameters so that the switch is reachable. You can manually configure the management interface from the CLI. You can configure the mgmt 0 interface with either IPv4 address parameters or an IPv6 address.

 

http://www.cisco.com/c/en/us/td/docs/switches/datacenter/mds9000/sw/6_2/configuration/guides/fundamentals/b_Cisco_MDS_9000_Series_NX-OS_Fundamentals_Configuration_Guide_Release_6_x/b_Cisco_MDS_9000_Series_NX-OS_Fundamentals_Configuration_Guide_Releas...

 

HTH

Sandy

0 Helpful

rosaho
Level 3
Level 3
In response to SANTHOSHKUMAR SARAVANAN

‎07-31-2015 06:45 PM

This discussion has been reposted from Cisco User Groups to the Storage Networking community.

0 Helpful
Customers Also Viewed These Support Documents