hardware failure

[ohomsky11]

I have a port hardware failure on MDS9509, and it still exist after replacing the gbic,also disabling & enabling the port didn't help.

any advise?

[#2]

The possible causes may be:

1)Not enough port indexes are available.

2)Available port indexes are non-contiguous

3)Not enough power is available in the chassis

For more information regarding this issue refer the below URL:

http://www.cisco.com/en/US/docs/storage/san_switches/mds9000/sw/rel_3_x/troubleshooting/guide/ts_hw2.html#wp86105

[ohomsky11]

Thanks, can you send me the information, as it prompts with an error on page when trying to open the link.

Oded.