- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-31-2018 07:26 PM - edited 03-01-2019 06:17 AM
Dear All :
I'm recovering the Nexus 9372PX from "Loader " mode . But after finished upload the nx-os . It's prompt the image signature verification failed . I had verify the image checksum was correct . But still fail .
Does anyone meet this error before ?
Ted Wen.
Solved! Go to Solution.
- Labels:
-
Other Storage Networking
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-01-2018 01:53 PM
https://supportforums.cisco.com/t5/data-center-videos/how-to-restore-a-cisco-nexus-switch-from-loader-prompt/ba-p/3101970
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-01-2018 04:49 PM
I'm using older nx-os to boot . It's work .
I had recovery this problem .
Thanks Ricky1776 and thanks all ~
Ted Wen,

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-01-2018 01:52 PM
Did you use the “install all” command? If not you’ll need to because it doesn’t have a kickstart image. This could be why it’s failing.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-01-2018 01:53 PM
https://supportforums.cisco.com/t5/data-center-videos/how-to-restore-a-cisco-nexus-switch-from-loader-prompt/ba-p/3101970
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-01-2018 04:49 PM
I'm using older nx-os to boot . It's work .
I had recovery this problem .
Thanks Ricky1776 and thanks all ~
Ted Wen,

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-01-2018 04:53 PM

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-08-2018 08:05 PM - edited 02-09-2018 07:20 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-18-2019 09:41 PM
HI Rick/Folks,
I also get the same failure when i downloaded the recent image 9.2.3/701 image.
https://software.cisco.com/download/home/285956855/type/282088129/release/9.2(3)
Can you please share the older image path that I could try? thanks
Filesystem type is tftp, using whole disk
.....................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................Image valid
Image Signature Verification Failed.
Boot failed
Error 9: Unknown boot failure
