Trying to connect 9124e blade switches to 9513 core switch.
cfs distribution enabled
vsans matches
on 9124e
- npv enabled
- host ports set to F
- external uplinks set to NP
- flex-attach enabled on host ports
on 9513
- npiv enabled
- ports set to F
now the uplink ports and ports and core switch are stuck in "init" state and npv status as follows
#show npv status
npiv is disabled
disruptive load balancing is disabled
External Interfaces:
====================
Interface: ext1, State: Failed(NPV internal FLOGI rejected by the upstream switch, Reason: 0x5, Reason Expl: 0x0)
Interface: ext2, State: Failed(NPV internal FLOGI rejected by the upstream switch, Reason: 0x5, Reason Expl: 0x0)
Interface: ext3, State: Pre-Initialized
Interface: ext4, State: Pre-Initialized
Number of External Interfaces: 4
Server Interfaces:
==================
Interface: bay6, VSAN: 100, State: Waiting for External Interface
Interface: bay5, VSAN: 100, State: Waiting for External Interface
Interface: bay7, VSAN: 100, State: Waiting for External Interface
Interface: bay4, VSAN: 100, State: Waiting for External Interface
Interface: bay3, VSAN: 100, State: Waiting for External Interface
Interface: bay2, VSAN: 100, State: Waiting for External Interface
Interface: bay1, VSAN: 100, State: Waiting for External Interface
Interface: bay8, VSAN: 100, State: Waiting for External Interface
Any clues?
