catalyst 2960G Switch

[Michael johansson]

Hi

I have a Cisco Catalyst 2960G-24TC-L Switch with i did a reset of by holding down the mode button until it reboored itself

After it rebooted i cant for my life get into with. I tried "Cisco, cisco, admin, password" and default combinations but i cant get in, can anyone tell me what's up?

[Charles Hill]

Hey Michael,

Sounds like the mode button was held down too long. 

Take a look at the document below for the password recovery procedure on a 2960.

http://www.cisco.com/c/en/us/support/docs/switches/catalyst-2950-series-switches/12040-pswdrec-2900xl.html

Hope this helps,

Please rate helpful posts.

Thanks.