cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
509
Views
5
Helpful
3
Replies

CBS250 - ACL works only until device reboots

Hubsi-Smith
Level 1
Level 1

Hello,

the Cisco CBS250 series is a plague.

Now, I have anther problem that I couldn´t solve.

I have a working output ACL assigned to a port where a camera is connected. Works so far good, until I reboot the camera.

The whole traffic is blocked by the switch until I remove my ACL and re-assign it.

 

I can´t explain why this happen? This behavior is senseless

3 Replies 3

marce1000
VIP
VIP

 

  - Check firmware version , use latest - if applicable.

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

There is no difference between 3.0.0.69 and 3.1.1.7 (latest).

Same configuration is working flawless with a C1000. Something is different on the CBS250 series.

I swapped the firmware 2 times and now all works like expected!

These kind of problems costs me a lot of my lifetime...

 

But in future we will keep off our hands from this serie and move back to Cisco Catalyst.

 

 @marce1000, thank you for your help. :top: