06-11-2013 12:06 AM
Hai, greeting.
I had followed the step in Quick Start Guide. I had set a static IP, for example 192.168.1.200 for my computer, but I can't connect to factory default IP address for Cisco SF300-24.
Anyone can help?
Best regard...
ITtrainee
Solved! Go to Solution.
06-11-2013 03:47 AM
Did you check this one from the docs:
When the device is using the factory default IP address of 192.168.1.254, its power
LED flashes continuously. When the device is using a DHCP assigned IP address or
an administrator-configured static IP address, the power LED is on solid.
http://www.cisco.com/en/US/docs/switches/lan/csbms/sf30x_sg30x/administration_guide/78-19308-01.pdf
06-11-2013 03:47 AM
Did you check this one from the docs:
When the device is using the factory default IP address of 192.168.1.254, its power
LED flashes continuously. When the device is using a DHCP assigned IP address or
an administrator-configured static IP address, the power LED is on solid.
http://www.cisco.com/en/US/docs/switches/lan/csbms/sf30x_sg30x/administration_guide/78-19308-01.pdf
07-08-2013 07:32 PM
Hi, I think the IPV4 Management and Interfaces section in the SF300 Administration Guide would help you.
Cisco Small Business 300 Series Managed Switch Administration Guide
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide