I created a port-group on both of my switches with 2 ports to increase the speed but I keep getting random losses in connection on both switches.
Cisco SG500
switch32f1d0#show interfaces port-channel 1
Load balancing: src-dst-mac.
Gathering information...
Channel Ports
------- -----
Po1 Active: gi1/1/49-50
show interfaces switchport port-channel 1
Port : Po1
Port Mode: Trunk
Gvrp Status: disabled
Ingress Filtering: true
Acceptable Frame Type: admitAll
Ingress UnTagged VLAN ( NATIVE ): 1
Port is member in:
Vlan Name Egress rule Port Membership Type
---- -------------------------------- ----------- --------------------
1 1 Untagged Static
41 Voice Tagged Static
100 100 Tagged Static
200 Premieter Tagged Static
300 Guest Tagged Static
400 Jace Closet Tagged Static
Forbidden VLANS:
Vlan Name
---- --------------------------------
Classification rules:
Protocol based VLANs:
Group ID Vlan ID
------------ -------
Mac based VLANs:
Group ID Vlan ID
Dell 5448
console# show interfaces port-channel 1
Load balancing: Layer 2.
Gathering information...
Channel Ports
------- -----
ch1 Active: g(43-44)
console# show interfaces switchport port-channel 1
Port : ch1
Port Mode: Trunk
Gvrp Status: disabled
Ingress Filtering: true
Acceptable Frame Type: admitAll
Ingress UnTagged VLAN ( NATIVE ): 1
Protected: Disabled
Port is member in:
Vlan Name Egress rule Port Membership Type
---- -------------------------------- ----------- --------------------
1 1 Untagged System
41 Voice Tagged Static
100 Internal Tagged Static
200 Perimeter Tagged Static
300 Guest Network Tagged Static
400 400 Tagged Static