SG500-52P - Add to Network

[tladd0001]

Hello,

I was hoping someone could help with a potentially easy (stupid) question.  I have powered up the switch and the system light is blinking green.  Now I want to and want to add it to an existing network.  According to the quick start guide, when I connect a laptop to one of the ports (which lights green), I should be able to configure the switch through a browser interface.  Initially I tried the factory default http://192.168.1.254 but receive a "You're not connected to a network" error.  Next, I tried to assign a static IP on the network adaptor.  After, when I tried to connect to the browser using that IP, I got the same result.

Any advice?

Thanks,

Tom

[pnguyen23]

have you tried to give your self the ip address of 192.168.1.250 and tried your browser again. also see if you can ping or ssh into it. 

[tladd0001]

That worked!  Thanks a million for your help!

Tom