This is my first time when I am usig Cisco Support Community to ask for help, so I apologise if I've done something wrong,
My cisco 2811 router - I was trying several types of resistors, to reduce the level of noise on the fans, so I could practice at night without waking up the baby. It worked fine, the same type of resistors are working ok on my other Cisco gear. After fitting the resistors, I have connect a console cable, just to make sure everything is OK, and I have notice that I cannot establish a console connection any more. nothing come's back on the screen, no signs, nothing at all.
I have tried changing the settings on the serial conection, (baud rate, stop bit) ... no results.
I don't know how to try any other types of connections, telnet etc... as I remember, I have no IP address configured on the switch for management, to try telnet using a FastEthernet port.
I have tried two console cables, all working on my other devices.
the last time when I was testing the resistors, the switch was powered ON, do you think that I have burned the console port?
It sounds like you are trying the right troubleshooting steps by varying speed and trying different console cables. If you have done these and when the router reboots you get no output on the console at all then damage to the console port would sounds like the issue.
Join us for the next Catalyst Tuesday session on March 9 - Enterprise Campus BGP EVPN Solution Overview :
This session will cover the Enterprise BGP EVPN Solution in the Campus using the Catalyst 9K platform. We will discuss the major drivers behind ...
Community Live- ISR1100X-4G and ISR1100X-6G Platform Overview and Architecture
(Live event - Tuesday, 23 March, 2021 at 10:00 am Pacific/ 1:00 pm Eastern / 7:00 pm Paris)-
This event will have place on Tuesday 23rd, March 2021 at 10:00 hrs PDT&...
Cisco Secure Network Access is helping IT to bridge the gap between what is essential to the business and what the network delivers and to build the next-generation campus network for an unplugged and uninterrupted experience.
Learn more about how these w...
(view in My Videos)
Community Live- New Additions to the Catalyst 8000 Family
(Live event - Tuesday, 23 February, 2021 at 10:00 am Pacific/ 1:00 pm Eastern / 7:00 pm Paris)-
This event had place on Tuesday 23rd, February 2021 at 10:00 hrs PDT...
This event had place on Tuesday 23rd, February 2021 at 10hrs PDT
Designed for an intent-based network, the Cisco Catalyst 8000 Edge Platforms family offers best-in-class networking and security combined. The platforms, available in b...