2960-S switch firmware upgrade path ?

[pfrancis3]

Hello, I have a stack of three 2960-S switches. They are currently running ' Version 12.2(53)SE2, RELEASE SOFTWARE (fc3'.

Is it OK to do a direct upgrade to 'c2960s-universalk9-tar.122-58.SE2' ? or is an incremental upgrade required ?

I understand I simply upgrade this to the master switch in the stack and it then propagates to the other switches.

Is there anything else important I need to be aware of ?

Thanks for any advice.

[jj27]

You can upgrade directly to that version of code.  Just be sure to use the archive download-sw command and it will transfer the image to all switches in the stack.  Good luck!