06-21-2018 09:53 AM - edited 03-08-2019 03:26 PM
Hi, Can anyone help me to understand that I have a switch port connected with an IP Phone and a PC but it is showing 3 mac addresses on this port. Phone is in voice vlan 30 and port is in vlan 10 but I see two mac addresses on vlan 10 and one on vlan 30 on this interface when i run sh mac-add-table inter <current>.
Can anyone explain that ? Thanks in advance.
06-21-2018 10:02 AM
Hi,
Lookup the mac address to find out the vendor. That might help.
Any other NIC on the PC? Wireless or Virtual?
06-27-2018 07:59 PM
Provides the output for ports G1/0/10 thru 19:
sh mac address-table | include Gi1/0/([1][0-9])
Provides the outputs for G1/0/20 thru 39:
sh mac address-table | include Gi1/0/([2-3][0-9])
06-27-2018 08:27 PM
can you share the switch port config?
is phone MAC address shown in both VLANs?
06-28-2018 02:12 AM
Are you sure no one has connected a switch to the interface?
Martin
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: