cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
747
Views
5
Helpful
6
Replies

3750 Qos - mls qos queue-set

chintan-shah
Level 3
Level 3

Hi,

I have to configure below CLI to allocate % buffer to all queue and set thrreshold but i don't know what is number 1 & 2 CLI , does it have any purpose ? or i can use any number ?

3750G(config)#mls qos queue-set output ?

<1-2> queue-set id

REgards,

Chintan

6 Replies 6

Yudong Wu
Level 7
Level 7

You can configure two sets of Qos queue parameters. Queue-set 1 and 2 are just two different sets of Qos queue parameter. By default, port will use queue-set 1. You can change it by "queue-set #" command under the interface.

Thanks, you mean i can change buffer value using default queue-set for all queue and no need to use queue-set 2.

Which scenario require to use both queue-set ?

sure you can.

For example, if you want some of the ports in switch use certain qos queue parameter and the others use a different one for some reasons.

Thanks, I got it.

Many thanks for help !!

Chintan

Hej Chintan,

You could for example assign "queue-set 1" to all of your user port and "queue-set 2" to the backbone trunk port.

int f0/1

description USER

queue-set 1

int g0/1

description UPLINK TO BACKBONE

queue-set 2

Thanks for further clarification. I am going to use same way now.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: