4500 module compatibility

[mark-kelley]

I have a 4506 (CatOS, WS-X4013 Sup.).

8.4(10)GLX SW version

This chassis currently has 2 of the following copper blades as well...

WS-X4448-GB-RJ45 (Qty. - 2)

I need to add a blade for additional copper ports...10/100 is fine for this situation..

Yes, I know this is an EOS switch/sup/etc...However, I have some spare blades

that are

WS-X4548-GB-RJ45V

Will these blades work in this switch is my question...If not, I guess we are going buy

some "used" 4448....

I have scoured the Cisco website for a 4500 blade compatibility w/o any luck....

Any help would be appreciated...

Thanks

[rsimoni]

Wow... the sup II was announced EoL in 2004!!! Niece piece of antiquary you own 

I tried to check in our db to see the supported hw for that engine but unfortunately all pages have been removed and/or archived and I could not find anything.

You just need to plug that LC and see if it is recognized.

regards,

Riccardo

[glen.grant]

Yes those will work ... Check release notes for catos 8.X  . Riccardo dont laugh we still have about 80 Cat4006 chassis running  even though they are end of life. :-)