Also Posted at WAN switching & routing by mistake.
We have two 4506's only doing layer2 and one Vlan
Another vlan is requested.
We don't want to mess with the WAN router.
Is it just a config to add routing and Vlan, or is an upgrade necessary?
Below is a look at the system.
Cisco Internetwork Operating System Software
IOS (tm) Catalyst 4000 L3 Switch Software (cat4000-I9S-M), Version 12.2(20)EW
RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Fri 29-Jul-05 18:09 by kellythw
Image text-base: 0x00000000, data-base: 0x011F8610
ROM: 12.2(20r)EW1
Dagobah Revision 226, Swamp Revision 34
System returned to ROM by reload
System restarted at 13:29:10 CST Sat Mar 3 2007
System image file is "bootflash:"
cisco WS-C4506 (MPC8245) processor (revision 10) with 262144K bytes of memory
Processor board ID FOX092603Q7
MPC8245 CPU at 266Mhz, Supervisor II+
Last reset from Reload
1 Virtual Ethernet/IEEE 802.3 interface(s)
192 FastEthernet/IEEE 802.3 interface(s)
2 Gigabit Ethernet/IEEE 802.3 interface(s)
511K bytes of non-volatile configuration memory.
