hi@alll
we have two 6509 switches configured with VSS. Few days ago we had a power cut and both switches was down.
After both switches coming up again but with issues.
installed IOS image is: s72033_rp_ADIPSERVICESK9_WAN_VM 12.2(33)SXI2a
I could find the issue on interface port-channel 110 for VSS Link.
When i disable this interface, the cpu comes down.
Problem is, both switch goes to active and not active/standby.
When i enable this interface again then VSS status come up and i have one active and one standby switch, but CPU is then very high.
see below the show command:
SolCen_VSS_Core#show switch virtual role
Switch Switch Status Preempt Priority Role Session ID
Number Oper(Conf) Oper(Conf) Local Remote
------------------------------------------------------------------
LOCAL 1 UP FALSE(N ) 100(100) ACTIVE 0 0
REMOTE 2 UP FALSE(N ) 100(100) STANDBY 4791 2587
In dual-active recovery mode: No
SolCen_VSS_Core#show switch virtual
Switch mode : Virtual Switch
Virtual switch domain number : 100
Local switch number : 1
Local switch operational role: Virtual Switch Active
Peer switch number : 2
Peer switch operational role : Virtual Switch Standby
SolCen_VSS_Core#show proces
SolCen_VSS_Core#show processes cpu sort
SolCen_VSS_Core#show processes cpu sorted
CPU utilization for five seconds: 100%/81%; one minute: 97%; five minutes: 64%
PID TID 5secUtil 1minUtil 5minUtil
16407 6 79.2% 75.3% 41.8%
16407 13 4.4% 2.5% 1.4%
16407 19 4.3% 2.2% 2.2%
16432 5 3.7% 1.5% 0.6%
16407 18 3.4% 2.8% 1.7%
16407 7 1.7% 3.1% 3.9%
16407 3 0.7% 1.8% 1.0%
16407 8 0.5% 0.5% 0.2%
16407 16 0.4% 2.5% 2.2%
And here the VSS configuration:
switch virtual domain 100
switch mode virtual
redundancy
main-cpu
auto-sync running-config
mode sso
interface Port-channel110
no switchport
no ip address
switch virtual link 1
mls qos trust cos
no mls qos channel-consistency
!
interface Port-channel120
no switchport
no ip address
switch virtual link 2
mls qos trust cos
no mls qos channel-consistency
interface TenGigabitEthernet1/5/4
no switchport
no ip address
mls qos trust cos
channel-group 110 mode on
!
interface TenGigabitEthernet1/5/5
no switchport
no ip address
mls qos trust cos
channel-group 110 mode on
interface TenGigabitEthernet2/5/4
no switchport
no ip address
mls qos trust cos
channel-group 120 mode on
!
interface TenGigabitEthernet2/5/5
no switchport
no ip address
mls qos trust cos
channel-group 120 mode on
!
interface GigabitEthernet1/9/47
no switchport
no ip address
dual-active fast-hello
interface GigabitEthernet2/9/47
no switchport
no ip address
dual-active fast-hello
We changed the X2-10GE-CX4 already but nothing happened. Same Issue.
Anybody a idea??
Thanks
regards
Matthias
